Description
ZW-HC101 applies periodically changing excitation signals at both ends of the electrodes to detect the output signal to determine the conductivity of the liquid to be measured. It has the characteristics of accurate measurement, fast response, long life and high reliability.
Application
Electrical conductivity detection in the field of automotive fuel cell antifreeze
Features
Easy to connect to third party devices such as PLC, DCS, industrial control computers, universal controllers, paperless recording instruments or touch screens.
Specifications
| On-line Conductivity Sensor | |
| Detection principle | Electrochemistry |
| Detection target | Coolant |
| Detection range | 0.01～20 uS/cm |
| Resolution ratio | 0.01uS/cm |
| Detection accuracy | ±1.5% F.S. |
| Operating voltage | DC (18～32)V |
| Power consumption | ＜1W |
| IP rating | IP68/IP6K9K |
| Operating temperature | -40℃～90℃ |
| Storage temperature | -40℃～90℃ |
| Operating pressure | ＜0.6 Mpa |
| Output mode | CAN/Analog quantity（Customizable） |
* The description and specifications might be changed without notice. Please contact us for the latest information before placing orders.
Technical Support:
Customized technical design and function, LOGO and package are available without extra charge (including molding fee) for mass volume.
The sensors don't have sleeping mode. It can be set in program if needed.
All Winsen products go through strict inspections and tests to make sure they are 100% qualified before shipping out.
The sensor has been fully tested (not calibrated) before leaving the factory. However, after transportation and storage, the environment conditions change, and the surface of the sensor absorbs moisture, mixed gas, pollution matters, etc. It is recommended that customers perform aging and calibration after sensors become stable according to the program and use occasions of the whole device.
15﹪-90﹪RH without condensation,greater or less than this range or long-term high temperature and high humidity will affect the life of the sensor.
Our sensors are certified with CE, 3C, ROHS, anti-explosion, fire prevention, and coal mining safety according to different applications. And we provide assistance for new certification.
Many factors can cause the sensor to fail such as broken wires in transportation, poisoning, falling off of the sensitive material, damage to the heating wire (device), etc. Please find specific cause in each category with Winsen’s aftersales.
Winsen provides professional consultation and service before and after sales. We will recommend the best fitting sensor for your demand. If you have any problem, don’t hesitate to email us to sales@winsensor.com
Due to high volume of daily incoming emails and time zone difference, we may not be able to reply your emails immediately. But we will reply to your inquiry in 24 business hours.
