WPAK69 General Type Isolation-Film Pressure Sensor
WPAK69 is clamp type pressure sensor with one-stage silicon oil filling technology. Pressure to the diaphragm is transmitted to the pressure chip through silicon oil, and the compensation circuit corrects the pressure signal to a linear electrical signal. The exposed stressed diaphragm on the end face of the clamp directly feels the pressure, which can prevent scaling, unsanitary, viscous pressure blockage and other problems. It is widely used in food, medicine, wine and other hygienic industries and in occasions where the measuring medium may scale.
- Process control system
- Pressure calibration instrument
- Hydraulic system
- Biomedical instruments
- Hydraulic system and valve
- Liquid level measurement
- Military equipment
- Refrigeration equipment and HAVC system
- Ships and navigation
- Aircraft and Avionics Systems
- Φ19mm standard OEM pressure sensor core, which is interchangeability with similar products at in market
- All stainless steel 316L package, anti-erosion
- Wide temperature compensation-10~+70℃
- Constant current and constant voltage excitation are optional
- Normalized output available
- Glue-filled and moisture-proof circuit board
|GaugePressure/AbsolutePressure/Sealed Gauge Pressure
|Can be customized
|Constant current：2kΩ～5KΩ； Constant Voltage：3kΩ～18kΩ
|Pin or Wiring
|Up to 90%FS
|Liquid and Gas
* The description and specifications might be changed without notice. Please contact us for the latest information before placing orders.
Customized technical design and function, LOGO and package are available without extra charge (including molding fee) for mass volume.
The sensors don't have sleeping mode. It can be set in program if needed.
All Winsen products go through strict inspections and tests to make sure they are 100% qualified before shipping out.
The sensor has been fully tested (not calibrated) before leaving the factory. However, after transportation and storage, the environment conditions change, and the surface of the sensor absorbs moisture, mixed gas, pollution matters, etc. It is recommended that customers perform aging and calibration after sensors become stable according to the program and use occasions of the whole device.
15﹪-90﹪RH without condensation,greater or less than this range or long-term high temperature and high humidity will affect the life of the sensor.
Our sensors are certified with CE, 3C, ROHS, anti-explosion, fire prevention, and coal mining safety according to different applications. And we provide assistance for new certification.
Many factors can cause the sensor to fail such as broken wires in transportation, poisoning, falling off of the sensitive material, damage to the heating wire (device), etc. Please find specific cause in each category with Winsen’s aftersales.
Winsen provides professional consultation and service before and after sales. We will recommend the best fitting sensor for your demand. If you have any problem, don’t hesitate to email us to email@example.com
Due to high volume of daily incoming emails and time zone difference, we may not be able to reply your emails immediately. But we will reply to your inquiry in 24 business hours.
LEADING GAS SENSING SOLUTION SUPPLIER
ZMT500-A Non-contact anti-dry probe
Infrared temperature measurement
Non-contact sensor, does not touch the bottom of the potVIEW MORE
ZE33 Water Heater Gas Leakage and Incomplete Combustion Detection Module
Sound and light alarm output, and PWM digital signal output modeVIEW MORE
MH-L1141A-U-100L Laser Sensor
Laser spectral absorption
High Sensitivity and resolution, low power consumption, small sizeVIEW MORE