MP-2 Smoke Gas Sensor
MP-2 model with advanced planar construction is comprised of heater and metal oxide semiconductor material of subminiature Al2O3 ceramic plate, fetch out electrode down-lead, encapsulation in metal base and cap. When the target gas exists , the sensor’s conductivity is more higher along with the gas concentration rising. Please use simple electrocircuit, convert change of conductivity to correspond output signal of gas concentration.
Domestic smoke leakage alarm, industrial smoke gas alarm and portable smoke detector.
- Good sensitivity to LPG, smoke in wide range
- Small size
- Long lifespan
- Low cost
- Simple circuit
|Sensor Type||Flat Surfaced Semiconductor|
|Standard Encapsulation||Metal Cap|
|Target Gas||C3H8, smoke|
|Detection range||200~10000ppm C3H8|
|Standard Circuit Conditions||Loop Voltage||Vc||≤10V DC|
|Heater Voltage||VH||5V±0.1V AC or DC|
|Sensor character under standard test conditions||Heater Resistance||RH||105Ω±10Ω (room tem.)|
|Sensitivity||S||Ro(in air)/Rs( in2000ppm C3H8)≥3|
|Output voltage||Vs||2.5V~4.0V (in 2000ppm C3H8)|
|Concentration Slope||α||≤0.6(R3000ppm/R500ppm C3H8)|
|Environment Conditions||Operation Temp.||Tao||-10℃~50℃|
|Relative Humidity||RH||Less than 95%RH|
|O2 concentration||O2||21%±1%(can’t less than 18%) O2 concentration effects sensor’s performance.|
|Preheat time||Not less than 48 hours|
* The description and specifications might be changed without notice. Please contact us for the latest information before placing orders.
Customized technical design and function, LOGO and package are available without extra charge (including molding fee) for mass volume.
The sensors don't have sleeping mode. It can be set in program if needed.
All Winsen products go through strict inspections and tests to make sure they are 100% qualified before shipping out.
The sensor has been fully tested (not calibrated) before leaving the factory. However, after transportation and storage, the environment conditions change, and the surface of the sensor absorbs moisture, mixed gas, pollution matters, etc. It is recommended that customers perform aging and calibration after sensors become stable according to the program and use occasions of the whole device.
15﹪-90﹪RH without condensation,greater or less than this range or long-term high temperature and high humidity will affect the life of the sensor.
Our sensors are certified with CE, 3C, ROHS, anti-explosion, fire prevention, and coal mining safety according to different applications. And we provide assistance for new certification.
Many factors can cause the sensor to fail such as broken wires in transportation, poisoning, falling off of the sensitive material, damage to the heating wire (device), etc. Please find specific cause in each category with Winsen’s aftersales.
Winsen provides professional consultation and service before and after sales. We will recommend the best fitting sensor for your demand. If you have any problem, don’t hesitate to email us to email@example.com
Due to high volume of daily incoming emails and time zone difference, we may not be able to reply your emails immediately. But we will reply to your inquiry in 24 business hours.